How to Install Tunnel LED Light
**CAUTION** Installation must be carried out by a licensed electrician
Parts List:
Parts Diagram:
Installation Steps (for Certified Electrician only):
Step 0 - Watch installation video first and use it as a supplement to the guide below.
Step 1 - Connect one end of the sloped bar (L2) that has no cable entry hole with the stand bar (L1), connect the red and black cables respectively using union (K1) as shown, and screw tight;
Step 2 - Connect the other end of the sloped bar (L2) that has a cable entry hole with the beam bar (L3), bring the cables from the sloped bar and the beam bar out of the cable entry hole as shown, and screw tight;
Step 3 - Repeat Step 1
Step 4 - Repeat Step 2, but connect the structure from Step 3 with the other end of the same beam bar (L3) in Step 2
Step 5 - Repeat Steps 1-4 for 5 more times to obtain 6 arch structures
Step 6 - Install the base (G1) and insert the arch structures into the bases, make sure they do not fall. Fix the arch structures from top with U connectors (G2) and connectors (G3). For each of the two sides, two U connectors (G2) are connected by one connector (G3), which then are fixed to the top of the 6 arch structures using screw B (Z2)
Step 7 - Connect wire cables.
* Red wires should connect with the anode/positive pole, and black wire should connect with the cathode/negative pole;
* Each terminal on the control system (D1) has a maximum power capacity of supporting 400W
* Again, this product should be installed by a certified electricians only
Connect wire cables on top of the arch structure using union (K2). See video.
As shown, a total of 12 wire cable holes in the entire structure where the wire cables come out of. Two wire cables come out of each wire cable hole. These wire cables are divided into four groups as shown below (each group should not exceed 400W) and connect to the control system (D1) as shown below. The four groups of wire cables should respectively connect with four terminals in parallel.